shift boot installation guide


Tools Needed:

Flathead Screwdriver

Philips Head Screwdriver

Needle-nose pliers or panel plug removal tool

Utility knife or sharp knife

Contact cement


Epoxy type adhesive


1. First, remove the door panel from the door. Start by removing the screws and clips shown in the picture.

2. Remove the soundproof mat

3. Remove the insert backing from the door by removing the clips holding them together.

4. A tight-nosed pliers would do the job perfectly. Remove the original insert skin.

5. Fit the insert against the door and make sure you have it aligned correctly. Apply contact cement to the insert and the backing, start placing the insert on one side on the surface of the backing. A second set of hands would be very handy - one person slowly lowers the insert to the backing and you use a putty or any dull object to make sure it sits smooth and there are no air bubbles underneath.

6. Reapply the soundproof mat.

7. Reinstall the insert on the door and proceed to the other door.



Useful tip

You have installed a product made out of genuine leather. As you know, to maintain a leather product in good condition, you should take care of it. We suggest occasionally (every 4-6 week for example) applying some leather conditioner/UV protector to keep your leather from drying up in the sun and cracking.

Redline Automotive Accessories Corp. will not be held liable for any labor, incidental or consequential damages of any kind. Proceed at your own risk. 

Copyright RedlineGoods.com. All rights reserved.

Save 20% today!


Please subscribe to our newsletter.

Get an instant 20% discount and enter our montly $100 CASH sweepstakes!

Get discount