1. Unscrew the shift knob. Remove the boot assembly by squeezing in on the sides at the base of the boot.

2. Separate the boot from the plastic bracket by prying off the four metal retaining clips.

3. Before installing your new shift boot, pry open the clips a bit so you don't make a mess of the boot.

4. Place the new boot around the plastic bracket, and slide the clips into place, then squeeze them down so they stay.

5. If your boot does not come with a "rolled lip" on the top, you may want to do this yourself. Just use a finger to push the top inside of itself as pictured.

6. Slide the assembly over the shift lever, being careful to preserve the rolled top. Face the wider part of the plastic bracket toward the front of the car. Squeeze the sides in and push down to get it to lock into place. Screw the shift knob back on and enjoy!

7. To install the ebrake boot, just slide it on top of the existing setup.

8. Make sure the elastic goes all the way in, nice and smooth around the plastic assembly.

CONGRATULATIONS - YOU HAVE SUCCESSFULLY INSTALLED YOUR NEW LEATHER BOOTS!

Useful tip

You have installed a product made out of genuine leather. As you know, to maintain a leather product in good condition, you should take care of it. We suggest occasionally (every 4-6 week for example) applying some leather conditioner/UV protector to keep your leather from drying up in the sun and cracking.

Redline Automotive Accessories Corp. will not be held liable for any labor, incidental or consequential damages of any kind. Proceed at your own risk.